Table of Contents
Contents
Introduction 3
About This Document 3
Conventions Used In This Document 3
General Notes 3-4
Connections 3
RS-232 Port Configuration 3
Ethernet Port Configuration 3
Ethernet Control 3
RS-485 Control 4
Site Identifier 4
Parameter Notes 5-7
Faders 5
Faders with User Min and User Max Limits 5
Buttons 6
Input and Output Selectors 6
Meters 6
LEDs 6
Other Parameters 6
Diagnostic Controls 6
Parameters That Cannot Be Controlled Externally 7
Getting Started 7
Protocol 7
Control Commands 7-13
(CS) Controller Set 7
(CSQ) Controller Set Quick 8
(CC) Change Controller 8
(GS) Get Controller 8
(GS2) Get Controller with Controller Number 9
(GPR) Get Preset 9
(GSB) Get Controller Block 9
(GSB2) Get Controller Block with Controller Number 10
(GSB3) Get Controller Block with Controller Number 10
(LP) Load Preset 11
(FU) Flash Unit LEDs 11
(SSYSS) Set System String 11
Dialing VoIP Strings 12
(GSYSS) Get System String 12
Pushing GSYSS String Values 13
Push Commands 13-15
Commands Related to Push 15-18
(PU) Global Push Enable/Disable 15
(PUE) Push Enable 16
(PUD) Push Disable 16
(GPU) Get Push-enabled Controllers 16
(PUR) Push Refresh 17
(PUC) Push Clear 17
(PUI) Set Push Interval 18
(PUT) Set Push Threshold 18
Setup Commands 19
(SB) Set Baud 19
(SQ) Set Quiet Mode 19
(EH) Set Echo Mode 19
System Commands 20
(NOP) No operation 20
(Q!) Quit TCP/IP session 20
(RI) IP address 20
(V) Version 20
(R!) Reboot 20
Special Command Prefixes 21
($e) Echo Mode 21
($v) Verbose Mode 21
($q) Quiet Mode 21
Super Matrix Mixer Control Protocol 21-24
Background 21
Features to Control 21
Commands 21
Basic Examples 22
Range Examples 23
Return Value 23
Polling for Changes 24
2 25
of
www.symetrix.co | T +1.425.778.7728
To Next Page
Loading...