Symetrix Composer v7.0 - System Commands; (NOP) no Operation; (Q!) Quit TCP;IP Session; (RI) IP Address

System Commands
NOP (No Operation)
The NOP command will always return an ACK in Quiet mode
to indicate that the system has received the command. The
NOP command can be used to keep a TCP connection
active or as a simple check of whether a system is up and
running and responding to commands.
Q! (Quit TCP/IP Session)
The Q! command will close the current TCP/IP session. If
the command is accepted, the unit will respond with the
string:
ACK<CR>
If the command is interpreted but fails for any reason the unit
will respond with the string:
NAK<CR>
A typical reason for failure is that the command was not sent
over a TCP/IP connection.
RI (IP address)
The RI command returns the IP address of the unit.
As an example:
RI<CR>
192.168.100.150
V (Version)
The V command returns the version of the software in the
unit. Up to thirteen different versions of software will be
returned corresponding to different subsystems within the
devices. For this command to be useful, it is recommended
to run the command while verbose mode is turned on
or temporarily turned on with the $v command prefix
(described in Special Command Prefix section).
As an example:
$v V <CR>
Firmware Version: V3.000
Build Date: Tue Apr 8 12:36:30 PDT 2014
Internal Build: V8.00
Linux Version: V3.2.0
Dante firmware: F:3.6.4 Sym:5.42
Startup firmware: V2.18
Front panel firmware: V2.29
RS-485 firmware: V1.25
RS-232 firmware: V1.55
TCP/IP firmware: V1.02
ARC-Web firmware: V1.10
ARC-Web executable: V1.09
ARC-Web CGI firmware: V1.09
Dialer CGI firmware: V1.55
Additional Info:
Linux version 3.2.0-ADI-2012R1-pre-9-pae+
(uclinux-devel@linux-tclw)
(gcc version 4.3.5 (ADI-2010R1-RC4) ) #3119 Tue
Nov 19 17:13:55 PST 2013 TCP/IP instance #1 of 4
>
R! (Reboot device)
The R! command will reboot the unit.
Special Command Prefixes
20 25
of
www.symetrix.co | T +1.425.778.7728