Symmetricom ATS-6511C

Need help?

Do you have a question about the Symmetricom ATS-6511C and is the answer not in the manual?

Summary

2 Installation

2.1 Powering on the ATS-6511

2.2 Communicating with the ATS-6511

Methods for establishing communication with the ATS-6511 system.

2.3 ATS-6511 Installation

2.4 ATS-6511 Modules

2.4.2 Output Cards

2.4.2.1 4394 A (PPS;DC IRIG)

2.4.2.5 4387 A (Modulated IRIG;NASA36)

2.4.2.6 4399 A (L-Band BPSK module)

2.5 Fiber Optic Input Behavior

How the ATS-6511 handles fiber optic input signals and switching.

2.5.1 Auto-Switching

Configuration and operation of the automatic fiber input switching feature.

2.5.2 Manual Switching

2.6 Fiber Modes;Calibration

Different fiber operating modes and calibration procedures for the ATS-6511.

2.6.1 Two Way Mode

Using two-way fiber mode for calibration and delay compensation.

2.6.2 Two Way Disabled

2.6.3 One-Way Fiber Calibration

2.6.4 Asymmetrical Fiber Paths

2.7 Setting the System On Time Point (OTP)

2.8 Using an External Frequency Reference (ATS-6511 B or C)

Connecting and configuring an external frequency reference for ATS-6511B/C.

2.9 System Configuration Files (Syscfg)

3 Operations

3.1 Front Panel

Understanding the indicators and controls on the ATS-6511 front panel.

3.1.1 Power Supply Indicators

3.1.2 Alarm Indicator

Function and meaning of the front panel alarm indicator light.

3.1.3 Oscillator Locked (Osc Lock) Indicator

3.1.4 Fiber A & B Indicators

3.1.5 Outputs Enabled Indicator

3.2 Rear Panel

3.3 Software

Managing and updating the ATS-6511 system software.

3.3.2 Software Updates

Procedures for updating the ATS-6511 software via flash card or remotely.

3.3.2.1 Flash Card Replacement

3.3.2.2 Remote Software Update

Performing software updates over the network using FTP.

3.4 User Interfaces

3.4.2 Telnet

Accessing the ATS-6511 via Telnet and using the command port (1700).

3.4.2.1 Command Port (1700)

Commands for remote system control via the command port.

3.4.3.2 Diagnostic Port (1800)

3.4.3.3 Status Port (1900)

3.5 Status Command

Retrieving system status, health, and measurement results using the status command.

3.6 System Verification

Steps to verify the system is operating correctly after setup.