10 4036B Operations and Maintenance Manual Rev. E
2: Installing and Setting Up the 4036B
2.1 Safety First!
Warnings:
This unit is for INDOOR USE ONLY. It is not protected against a harmful ingress of moisture.
Do not attempt to install or operate this equipment if you have not first acquired proper training.
Equipment is intended to be installed in an Enclosed or Open type equipment rack
Ensure that all cables are properly connected. The power cord must be easy to remove from the
back.
Verify that input line voltage and current capacity are within specifications before turning on
power to the unit.
Disconnect all sources of input power before removing the top cover of this unit.
Operating and maintenance personnel must receive proper training before installing or
maintaining electrical equipment.
2.2 Unpacking
To unpack the TSC 4036B unit:
1. Unpack and carefully inspect the unit.
2. Check for physical damage.
3. If no physical damage is apparent, then proceed with making appropriate connections.
î
If physical damage is observed, then immediately contact Symmetricom and the
carrier.
4. Save the shipping container for submitting any necessary claims to the carrier.
To Next Page
Loading...
Need help?
General
