Duro
®
Model Numbers Specification
Options/Modifications
3603-H321-V
Hand shower system powered by the Temptrol
®
pressure
balancing valve. Features adjustable stop screw to limit
handle turn, lever handle, wall connection, 30" slide bar,
in-line vacuum breaker, exible metal hose, 1 mode hand
shower and standard 2.5 gpm (9.5 L/min) ow restrictor.
3605-H321-V
Shower/hand shower system powered by the Temptrol
®
pressure-balancing valve. Features adjustable stop screw
to limit handle turn, separate two function diverter, lever
handle, wall connection, 30" slide bar, in-line vacuum
breaker, exible metal hose, 1 mode hand shower,
1 mode showerhead and standard 2.5 gpm (9.5 L/min)
ow restrictors.
3606-H321-V
Tub/shower/hand shower system powered by the
Temptrol
®
pressure balancing valve. Features adjustable
stop screw to limit handle turn, separate three function
diverter, lever handle, wall connection, 30" slide bar,
in-line vacuum breaker, exible metal hose, non-diverter
tub spout, 1 mode hand shower, 1 mode showerhead with
standard 2.5 gpm (9.5 L/min) ow restrictors.
Components made from metal and nonmetallic materials
plated in standard polished chrome nish.
3603-H321-V
Hand Shower System
3605-H321-V
Shower/Hand Shower System
Note: Append appropriate -sufx to model number.
3606-H321-V
Tub/Shower/Hand Shower System
Compliance
-ASME A112.18.1/CSA B125.1
Warranty
Limited Lifetime - to the original end purchaser in
consumer/residential installations.
5 Years - for industrial/commercial installations.
Refer to www.symmons.com/warranty for complete
warranty information.
3603-H321-V, 3605-H321-V, 3606-H321-V
Duro™ Shower System Series
Operation & Maintenance Manual
-1.5 1.5 gpm (5.7 L/min) flow restrictor
-2.0 2.0 gpm (7.6 L/min) flow restrictor
-IPS
1/2" female IPS connections
-LW
Wide lever handle (chrome finish only)
-REV Reverse coring, hot on right, cold on
left, for back to back installations
-SS Slip spout on any tub and shower unit
-T736 36" slide bar/grab bar with ADA hand
shower in place of standard hand
shower unit
-X Integral service stops - allows water
shutoff at valve for service
-CHKS Integral check stops - for use in
installations where a positive shut-off
device is used downstream of mixing valve
-STN Satin Nickel finish
-TRM Trim only, valve not included
To Next Page
General
