SymNet ExpressCobra Series - Mechanical and Physical Specifications

6408 216th Street SW | Mountlake Terrace, WA 98043 USA
T +1.425.778.7728 F +1.425.778.7727 | www.SymetrixAudio.com
6
Quick Start Guide
MechData•Front/RearPanel
Mechanical Data
Item Specifications Remarks
SPACE REQUIRED 1U(WDH:48.3cmx27.4cmx4.37cm/19
inx10.8inx1.72in).Depthdoesnotinclude
connector allowance.
Allow at least 1 inch additional clearance for rear panel connections. Additional depth
may be required depending upon your specific wiring and connections.
ELECTRICAL 100 to 240 VAC, 50-60 Hz, 60 watts maximum. No line voltage switching required.
VENTILATION Maximumrecommendedambientoperating
temperatureis30C/86F.
Fan on equipment right pulls hot air out of unit. Air intake at equipment left. Ensure that
theleftandrightequipmentsidesareunobstructed(5.08cm,2inminimumclearance).
The ventilation should not be impeded by covering the ventilation openings with items
such as newspapers, tablecloths, curtains, etc.
WEIGHT 6 kg (12 lbs.)
Front Panel
Item Description Remarks
POWER Red LED Indicates that the device is powered on.
LEDislitsolidwhenoperatingfromtheMAINPOWER.
LEDisflashingwhenoperatingfromtheAUXPOWER.
Note:TheLEDwillflashthenumberoftimesequivalenttoitsRINGNUMBERuponpowerup.
COMM Yellow LED Indicates current host communications.
COBRANET Green LED Indicates a valid CobraNet connection.
SIGNAL LEVEL Bi-colorLEDs Indicates input or output signal level with four levels of intensity
(OFF,-48dBFS,-24dBFS,-12dBFS)andsignalclipping(0dBFS).
•InputlevelisindicatedinORANGE.
•OutputlevelisindicatedinGREEN.•ClippingisindicatedinRED.
Rear Panel
Item Description Remarks
POWER INPUT IEC 3 prong jack Accepts power from detachable IEC power cable (100-240 VAC, 50-60 Hz, 25 Watts max).
AUX POWER MaleXLR-4jack AcceptspowerfromSymetrixmodelPS-7oruser-suppliedauxiliarypowerconnection(24VDC,2.5Amps,
60 Watts max).
NOTE: Detachable Euroblock connectors are designed for use with bare wire. Do not tin stranded wires before inserting them into the connectors.