operation
210 Synrad Firestar ti-Series operator’s manual
Initial start-up
7
On water-cooled lasers, shut off the chiller or otherwise stop coolant flow through the laser.
Caution
possible
equipment
damage
Do not flow coolant through the laser for an extended period of time
when the laser is shutdown. This causes condensation to form inside
the laser that may result in catastrophic damage to internal optics
and electronic circuits.
If your Firestar ti-Series laser fails to lase, refer to Troubleshooting in the Maintenance/Troubleshooting
chapter for troubleshooting information.
To Next Page
Loading...