Danger
serious
personal
injury
Direct or diffuse laser radiation can inflict severe bodily damage, including, but not
limited to, permanent eye damage or blindness, and severe burns to human or animal
tissue. Always wear the appropriate eye protection when in the same area as an operat-
ing laser. Do not allow a direct or reflected beam to contact a person.
Always be aware of the laser’s beam path when using a laser power meter and always
use a beam block to prevent the beam from traveling beyond the intended work area.
SYNRAD, Inc.
4600 Campus Place
Mukilteo, WA 98275
tel 1.425.349.3500
fax 1.425.349.3667
e-mail synrad@synrad.com
web www.synrad.com
Rev 3 / 18 Apr 2014
P/N 900-00005-02
Power Wizard PW-250 Operating
Instructions
Important Note: Power Wizard
®
power meters are designed as diagnostic and service tools for verifying laser power.
They are not intended for use in validating critical process parameters and should not be used in such
applications.
Note: Read these instructions thoroughly before using the PW-250. Certain steps in the measurement process must be
made in a timely manner to prevent erroneous power readings.
Setup
1
Position a beam block in a manner that prevents the laser beam from traveling beyond the work area during power
measurements.
2
Ensure that all personnel in the area are wearing the appropriate protective eyewear.
3
Apply power to the laser. Enable lasing just as you are ready to begin power measurements.
To Next Page
Need help?
General
