1 p250 Laser Quick Start Guide Version 3.1
p250 Quick Start Guide
1.1 Two places for both people at
opposite ends of the box for lifting.
Potential
Lifting
Injury
Use two people at a minimum to lift and/or
move the laser.
Use carts to minimize risk.
Danger
Two
Caution! Unpacking the wire harness incorrectly can lead to damage.
Keep All specially designed Foam Packaging and end-caps, you will need to re-use it
when re-packaging/moving your laser. Refer to this guide and the Technical Reference
chapters in the laser’s Operation Manual when re-packaging for shipping and/or reloca-
tion.
If you discover shipping damage, document the damage (photographically if possible), then immediately no-
tify the shipping carrier (responsible party) and SYNRAD. After unpacking, review the Inventory list in the Intro
section within the operators manual.
If you need a replacement box for packing and/or shipping your laser, contact us.
Caution! When re-packing the laser for relocation or shipment, nothing can be on the sides of the laser
at any time as damage will occur. There is only one way the laser ts into the foam! All components must
be stowed under the laser. Re-package the wire harness as shown above. The wire harness &/or ports can
be damaged in shipping if not re-packaged as shown in this guide, the drawings, operation manual, and/or
resources located in our website.
Caution
Possible equip-
ment damage
Mounting feet and/or rails are optional, for complete details, refer to the laser’s Operator’s Manual and draw-
ings and Mounting located on our website.
Laser Unpacking:
Important
Note:
See your Marking Head (If utilized) and the Pulstar p100/150 Operators Manual for com-
plete installation details and instructions.
Read all Danger, Warning, Caution terms, symbols, and instructions located in
the (Laser Safety Hazard information) sections in the Laser’s Operation Manual and in
our Laser Safety/Compliance 101 on our website.
To Next Page
Need help?
General
