Synrad p250 - Electrical and Control Connections; DC Power Cable Routing and Fasteners; Laser Control Cabling

16 p250 Laser Quick Start Guide Version 3.1
250
p250 Quick Start Guide
Place the DC power
sense cables here if using
your own power source.
Place the DC sense
cables here if using.
Important
Note:
Only M10 (brass) fas-
teners provided should
be used on all DC-con-
nections on the laser.
48 VDC Power (+)
Ground (-)
Electrical Connections (Continued):
Warning!
Serious
personal
injury
The Quick Start Plug bypasses the laser’s safety interlock function poten-
tially exposing personnel to hazardous invisible infrared laser radiation.
Remove DC power before installing or removing the Quick Start Plug. Please
refer to the (Connecng-laser connecons & the following Quick Start Plug) sec-
ons in the p250 Operator’s Manual.
Quick Start Plug
(QSP)
Control Connections:
21. Connect the Ethernet & BNC (Laser Control) cabling per the SYNRAD marking head QSG. If using the
QSP, see your Laser’s Operators Manual. If you aren’t using a SYNRAD marking head, go to the next
section.