SYSMEX KX-21 - Page 306

Sysmex KX-21 Operator’s Manual -- Revised October 1998 iii
Reset Sampling Valve (SRV)
Cycle Counter -------------------------4-22
Right Side Panel------------------------------9-32
Rinse Motor Error -------------------- 7-13, 7-14
Room Temp. High---------------------------7-16
Room Temp. Low----------------------------7-16
S
Sampling Error------------------------ 7-18, 7-19
Select QC File ----------------------------------5-5
Selecting Automatic Calibration Parameter--6-4
Selecting Pre-Diluted Mode-----------------2-18
Selecting Whole Blood Mode---------------2-10
Set Printer Paper -----------------------------A-10
Set TARGET/LIMIT Values ------------------5-7
Set Value Error-------------------------------7-23
Shutdown Procedure-------------------------2-30
Software---------------------------------------- B-3
Start-up Procedure-----------------------------2-3
Status Display --------------------------------7-34
Status Display Messages-----------------------1-8
Stopping the Pneumatic Unit ---------------2-29
Stored Data Screen---------------------------3-12
Supplies List----------------------------------4-40
Supplies Replacement -----------------------4-33
System Setup --------------------------------- 10-2
T
Troubleshooting Guide------------------------7-7
Troubleshooting Guide
(Analysis Errors)----------------------7-17
Troubleshooting Guide
(Built-in Printer Errors) --------------7-30
Troubleshooting Guide
(Chamber Errors)---------------------7-10
Troubleshooting Guide
(External Device Errors) -------------7-33
Troubleshooting Guide
(Maintenance Errors) --------------7-27
Troubleshooting Guide (Memory Errors)- 7-23
Troubleshooting Guide (Motor Errors)----7-13
Troubleshooting Guide (Others) -----------7-25
Troubleshooting Guide
(Pressure/Vacuum Errors)--------------7-7
Troubleshooting Guide
(Temperature Errors)-----------------7-16
Troubleshooting Guide
(Transducer Errors)-------------------7-15
Turn Power On-------------------------------A-12
Turning ON the Power and Self-Check------2-5
U
Updating Calibration Value
(Manual Calibration) -----------------6-12
Updating Calibration Value
(Automatic Calibration) ----------------6-8
W
Waste Not Draining --------------------------7-10
WBC Aperture Clog--------------------------7-15
WBC Discriminator --------------------------9-10
WBC/HGB Analysis Error -------------------7-21
WBC/HGB Analysis Flow----------------------9-5
Weekly Maintenance and Procedure ---------4-7
When You Suspect A Trouble ----------------7-2
Whole Blood (WB) Mode ---------------------2-9
X
X
Control---------------------------------------5-1