SYSMEX CS-5100 LAS User Manual

CS-5100 LAS
Instructions for Use
CHAPTER 1 Introduction
CHAPTER 2 Basic Operations
CHAPTER 3 Performing Analysis
CHAPTER 4 Checking Analysis Results
CHAPTER 5 Performing QC Analysis
CHAPTER 6 Setting Up the System
CHAPTER 7 Customizing Screen Displays
CHAPTER 8 Creating Calibration Curves
CHAPTER 9 Troubleshooting
Index
KOBE, JAPAN
Code No. BL022510
SMN: 11209614
Date of Last Revision: October 2014
Software Version: 01-13 onwards
© SYSMEX CORPORATION 2012-2014

SYSMEX CS-5100 LAS Specifications

General

Category	Laboratory Equipment
Type	Automated Blood Coagulation Analyzer
Throughput	Up to 400 tests/hour
Operating Temperature	15-30°C
Measurement methods	Clotting, chromogenic
Sample types	Plasma
Reagent storage	On-board refrigerated storage
Sample Capacity	100 sample positions
Reagent Capacity	80 reagent positions
Power Supply	AC 220-240 V, 50/60 Hz
Connectivity	LAN
Number of channels	4 optical detection channels
Operating Humidity	30 - 80% (non-condensing)

Summary

Chapter 1 Introduction

1.1 Hazards in this manual

Details potential hazards and safety precautions associated with using the manual.

Chapter 2 Basic Operations

2.1 Turning ON the power

Instructions for powering on the CS-5100 instrument and the LAS system.

2.2 Checking the LAS connection status

2.3 Disconnecting the LAS

2.4 Shutting down

Steps for properly shutting down the instrument.

Chapter 3 Performing Analysis

3.1 Analyzing the sample on the tracks

Procedure for analyzing samples that are transported on the LAS tracks.

3.2 Analyzing a sample while analyzing another sample on the tracks

How to analyze additional samples (sampler or STAT) alongside track samples.

Chapter 4 Checking Analysis Results

Chapter 5 Performing QC Analysis

5.1 Performing the QC analysis with the control set on the CS-5100 before analyzing a sample on the tracks

5.2 Performing the QC analysis with the control set on the CS-5100 while analyzing a sample on the tracks

5.3 Performing the QC analysis for the tracks

Chapter 6 Setting Up the System

Chapter 8 Creating Calibration Curves

8.1 Creating a calibration curve before analyzing a sample on the tracks

8.2 Creating a calibration curve while analyzing a sample on the tracks

Chapter 9 Troubleshooting

9.1 Causes of errors and corrective actions

Lists common error codes for the LAS and provides corresponding corrective actions.