SYSMEX CS-5100 LAS - 1.1 Hazards in this manual

Chapter 1 Introduction
CS-5100 LAS Instructions for Use
Revised October 2014
1-2
1.1 Hazards in this manual
1.2 Protected names
• Sysmex is a registered trademark of SYSMEX CORPORATION.
• Other registered trademarks or trademarks referenced are property of their respective owners.
The fact that a trademark is not explicitly mentioned in this manual does not authorize its use.
1.3 Conditions of use
Please be advised that the following conditions apply when analyzing a sample from the tracks:
Analysis method
The instrument analyzes the sample on the tracks after it acquired the order information from the host computer
according to the sample ID that was identified by the LAS. You cannot register an order manually.
Analysis mode
All of the analysis will be carried out in normal mode.
This system does not support the micro-sample mode.
Usable sample tubes
A capped sample tube cannot be used for any analysis.
* The usable sample tube type and required sample volume are the same as the ones required for the CS-5100.
(➤ CS-5100 Instructions for Use “Chapter 1: 1.5 Product information”)
Risk of infection
This symbol indicates a possible hazardous situation which, if not avoided, may result in
infection by pathogens and others.
Caution!
Average risk. Ignoring this warning could result in property damage or incorrect analysis results.
Note:
Background information and practical tips.