To Next PageTo Next PageWhat to do if fluid leaks from SYSMEX KX-21 Laboratory Equipment?
If fluid leaks from the SYSMEX Laboratory Equipment, immediately turn OFF the power and wipe off the leaking fluid. If the fluid leakage continues after turning the power back ON, it is recommended to contact your Sysmex service representative.
Why does SYSMEX KX-21 display 'PU Sleeping' and not respond?
If the SYSMEX Laboratory Equipment displays the 'PU Sleeping' message and does not accept any key entries, it means the timer mode has turned OFF the pneumatic unit power. To bring the instrument back to ready status, press the [SELECT] key to return to the analysis result screen, and then press the [Start] switch.
How to troubleshoot SYSMEX Laboratory Equipment that won't turn on?
If the SYSMEX Laboratory Equipment does not start when you turn the power ON, check the following: * Ensure the power cord is securely connected. * Check if the fuse is blown. * Verify that the AC outlet is supplying power.
Why is my SYSMEX KX-21 Laboratory Equipment beeping with a blank screen?
If the SYSMEX Laboratory Equipment is ON but nothing is displayed and a 'beep' keeps sounding, it is possible that a memory error has occurred. Turn OFF the power, and then turn it ON again after 1 to 2 minutes.
General| Type | Automated Hematology Analyzer |
|---|---|
| Throughput | 60 samples per hour |
| Operating Temperature | 15-30°C |
| Parameters | WBC, RBC, HGB, HCT, MCV, MCH, MCHC, PLT, LYM%, MXD%, NEUT%, LYM#, MXD#, NEUT# |
| Display | LCD |
| Power Supply | 100-240V, 50/60Hz |
| Operating Humidity | 30-85% |
Explains the main functions of the KX-21 analyzer and its optional units for efficient operation.
Lists and describes the 18 parameters analyzed by the instrument using three detector blocks.
Lists the technical specifications including analysis parameters, reagents, and power supply.
Details the process of powering on the unit, self-check, auto rinse, and background check.
Explains the steps for analyzing samples in both Whole Blood (WB) and Pre-Diluted (PD) modes.
Details daily tasks like cleaning chambers and checking trap levels.
Explains how to replenish reagents, replace fuses, and printer paper.
Details the procedure for performing quality control using the X control method.
Explains how to perform quality control using the Levy-Jennings (L-J) control method.
Provides detailed guidance on diagnosing and resolving common instrument errors by category.
Explains how to adjust the instrument's pressure and vacuum levels.
Provides specific steps to adjust the pressure regulator to the correct level.
Details the procedure for adjusting the vacuum to the specified level.
