System Cleaners MS5 - PS1 and PS3 Technical Specifications; PS1;PS3 Pump and Electrical Details; PS1;PS3 Water and Air Inlet Specs

Version 9 (02.2018. EN) (MS5, MS7, PS1, PS3, PS5, PS7)
Page 43 of 48
Model
PS1
PS3
Installation
Ambient temperature
3-40°C / 37-104°F
Pump
Pump type
CRNE 3-9J
CRNE 3-9J
Motor power
2.2 kW / 3 HP
4 kW / 5.4 HP
Frequency drive
Integrated in pump motor
Degree of protection
IP 54
Connections
In- and outlet
1½” BSP or NPT
Water, inlet
Pressure
1.5-10 bar / 23-150 psi
Maximum pump cut-out pressure
1.5 bar / 22 psi
Temperature
3-70°C / 37-160°F
Minimum pump cut-out temperature
90°C / 190°F
Minimum recommended flow
4.5 m³/h / 18 USgal/min
4.5 m³/h / 18 USgal/min
Water, outlet
Setpoint
20 bar / 290 psi
Maximum flow at 20 bar (290 psi)
(including 4.0 bar (58 psi) inlet
pressure)
30 liter/min / 7.9 US gal/min
90 liter/min / 23.8 US gal/min
Air, inlet
Pressure
-
-
Minimum flow
-
-
Electrical 230V
Voltage and frequency
3x208-230V +/- 10% 50-60 Hz
Not available
Current
8 A
Recommended pre-fusing
16 A
Recommended cable cross section
4 x 1.5 mm² / 4 x AWG16
Electrical 400 and 460V
Voltage and frequency
3x380-500V +/- 10% 50-60 Hz
Current
3.4-4.15 A
6.2-7.6 A
Recommended pre-fusing
10 A
16 A
Recommended cable cross section
4 x 1.5 mm² / 4 x AWG16
4 x 1.5 mm² / 4 x AWG14
Chemical
Dosing range
-
-
Dimensions
Weight
125 kg /
276 lbs
150 kg /
331 lbs