SystemAir SYS WSC 86

No.
Parameter displayed on the wired controller during ODU spot check
37 Reserved 2
38
Reserved 2
No. Parameter displayed on the wired controller during IDU spot check
1
IDU communication address
2 Capacity (HP) of IDU
3
IDU network address (the same as the communication address)
4 Set temperature Ts
5
Room temperature T1
6 Actual T2 indoor temperature
7
Actual T2A indoor temperature
8 Actual T2B indoor temperature
9
Ta temperature (FAPU)
11
Target superheat degree (reserved)
12 EXV position/8
13
Software version No.
14 Error Code
Compressor discharge temperature (show high discharge temperature) 10
36
Table 6.2