T-Fal GENIO 2 User Manual

8
EN
FIRST USE
XL
STOP
XL
STOP
XL
XL
XL
1
4
7
2
5
8 9
3
30 sec
ON
6
Rinse water tank at rst. Fill water tank with
fresh, drinking water. Place cap and insert
water tank into machine.
Start rinsing with cold water:
Push the lever up to set the bar display to
maximum level. Move lever to the left for cold
water rinsing.
Machine starts rinsing. Wait until countdown is
nished and machine stops.
Open locking handle and insert empty capsule
holder. Close locking handle. Place capsule
bin under coee outlet. Connect power plug to
mains power socket.
Machine starts rinsing. Wait until countdown is
nished and machine stops.
Empty capsule bin and rell water tank with
fresh, drinking water.
Remove protection foil from drip grid. Place
drip grid on drip tray. Then attach drip tray at
desired position on machine.
Switch machine on. While machine is heat-
ing up, power button starts blinking red. After
approx. 30 seconds, power button light turns
steady green and machine is ready.
Continue rinsing with hot water:
Push the lever up to set the bar display to
maximum level. Move lever to the right for hot
water rinsing.

T-Fal GENIO 2 Specifications

General

Brand	T-Fal
Model	GENIO 2
Category	Coffee Maker
Language	English