EasyManua.ls Logo

T-Fal SENSOR 2 - T-Fal Answers Your Questions; Troubleshooting Common Issues

T-Fal SENSOR 2
19 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
If you can’t close the cover:
If the Pressure Cooker has heated
without any liquid inside:
If the pressure indicator pin has not
risen and no steam is released from
the valve during cooking:
If the pressure indicator pin has risen
and no steam is released from the
valve during cooking:
If steam escapes from under the
cover, check that:
If one of the safety systems (safety
valve or gasket) is activated:
If you cannot open the cover:
If the food is under-cooked or burnt,
check:
If food has burnt in the Pressure
Cooker:
If one of the safety systems comes
into operation:
Check the position of the lock undermeath the covers
handle. If it is not in the forward position, hold the cover and
push it forward.
Have your Pressure Cooker checked by an Authorized
T-Fal After-Sales Service Center.
This is normal for the first few minutes.
If this persists check that:
The heat setting is high enough. If not turn it up.
There is enough liquid in the pot (see page 5).
The pressure regulator valve is set to 1 or 2.
The Pressure Cooker is properly closed.
The gasket and the rim of the pot are not damaged.
Put your Pressure Cooker under cold water to decompress.
Clean the pressure regulator valve and the steam outlet.
The cover is properly closed.
The gasket is properly in place.
The gasket is in good condition. If not, replace it.
The rim of the pot is in good condition.
The cover, safety valve, pressure regulator valve and
gasket are clean.
Turn off the heat.
Allow the Pressure Cooker to cool down.
Check the pressure regulator valve and the steam outlet.
Check that the pressure indicator pin is in low position.
If not, cool the Pressure Cooker under cold running water
to release the pressure.
The cooking time.
The heat setting used.
The positioning of the pressure regulator valve.
The quantity of liquid used.
Allow the pot to soak in warm soapy water for a while
before washing.
Never use bleach or chlorine products.
Turn the heat off.
Let the Pressure Cooker cool down.
Open.
Check and clean the pressure regulator valve, steam outlet,
safety valve and gasket.
If the third safety device comes into operation, have your
Pressure Cooker checked by an Authorized T-Fal After-Sales
Service Center.
T-Fal
answers your questions
14
Sensor II USA 4131340 12/03/02 10:15 Page 14

Related product manuals