3
STEP 2 Change HDMI Input to Tablo
Using your TV’s remote, select the HDMI input that you have your Tablo DVR connected to.
STEP 3 Setting Up the Tablo Remote
On the back side of the remote, slide open the battery cover. Insert batteries (included).
Your remote should pair with your DVR automatically.
STEP 4 Follow the Tablo DVR Setup Wizard
The setup wizard will walk you through connecting Tablo to the internet over WiFi (if not already
connected by Ethernet) and then it will perform a channel scan to determine what channels can
be received by your antenna.
You can add/remove recommended
channels from your guide at this time.
Be sure to select ‘Rescan’ if you
change or adjust your antenna’s
position after the initial channel scan.
The wizard will also ask to format
your USB hard drive.
Is your lineup missing local channels
you expected to see? Is your Tablo
DVR not nding any channels during
a scan? Visit www.TabloTV.com/
channelscan for help.
To Next Page
Loading...