Tachosys digiPostpro - Digivu Vehicle Download Settings; Driver Card Download Settings

Configuring Your digivu
Configuring Your digivuConfiguring Your digivu
Configuring Your digivu
Page - 22
Delete All
Use this option with caution as if you have not
uploaded les to the main server they will be
permanently lost. Under File System in the digivu
conguration menu, you are given the option of
deleting all les from the device. To do so, press the OK button.
You will then receive a security message asking whether you are
sure you want to delete all les. Choose the green tick and press
OK to conrm deletion.
Vehicle Download
The Vehicle Download menu allows you to set what
information the digivu downloads from the VU. You
have four settings:
Standard Download
This option shows you a list of numbers (01-05). The numbers
represent which vehicle le sections are enabled on your digivu.
To view a table of what each section number means, see the table
in ‘Troubleshooting’ on page 24.
To edit which sections are enabled, highlight the Standard
Download option and press OK. This will give a further 4
customisable options.
Activity (02) sets what information is downloaded while the other
three options, Events and Faults (03); Speed Data (04) and
Technical Data (05), are all simply on/o.
Special Data
When Special Data is turned on it creates a separate ‘S’ prexed
le on your download device. This le is created only for VDO
Tachographs, and will contain 4hz speed data which can be
analysed with appropriate software.
Configuring Your digivu
Configuring Your digivuConfiguring Your digivu
Configuring Your digivu
Page - 23
Driver Card
By turning on the Driver Card option, this will enable the digivu to
download driver card les from the tachograph unit if present.
This saves the driver having to download his information
separately.
Download Speed
Scrolling left/right on this option reveals three choices;
Optimised, Standard and Slow.
Optimised: This will download les at the fastest achievable rate
given the Tachograph unit type and rmware release.
Standard: This will run as per the absolute requirements of the
Annex 1b / 1c standards, irrespective of Tachograph type.
Slow: If you are having download issues, using Slow will set the
download speed at a slower rate than the absolute requirements.
Download Log
In the Download Log menu there are a further two
options: Read Log and Clear Log
Read Log shows a list of downloads performed by the
digivu. For each download it gives the date, time and either
driver card number or vehicle reg. number depending on whether
it has downloaded driver card or VU les. It will also display error
codes to diagnose any failed downloads.
Clear Log allows you to delete the download log held on
the download device. For security, it will ask you for conrmation.
Information
The Information icon will display the information of the
divigu attached. It will display the digivu’s Serial
Number, Build Date and Time and the version of
rmware installed.