Tachosys digiPostpro - Digifobpro Connection; Configuring Your Digivu; Digivu Configuration via Digipostpro; Digivu File System Management

Maintaining and Transferring Files
Maintaining and Transferring FilesMaintaining and Transferring Files
Maintaining and Transferring Files
Page - 20
digifobpro
To connect a digifobpro use the same cable that connects the
digifobpro to the Vehicle Unit (spare part code: DFP02-TC),
placing the cable in the front socket of the digipostpro.
Please note that if you are using an original digifobpro (1st
generation), the cable used will have the same socket/plug at
both ends - it does not matter which end goes in the digipostpro.
The le transfer will start automatically and a progress bar
indicates the progress of each transfer. When the transfer is
complete an alert will sound (if enabled) and a digifobpro with
tick icon will be displayed. Simply disconnect your digifobpro
from the device.
Archived Files
Once les from a digifobpro or digivu have been transferred to a
digipostpro, it will mark the transferred les on the digifobpro
and digivu as archived. If the download device is plugged in
again, it will not transfer archived les. Only new or unarchived
les will be transferred.
If required, les can be manually archived or unarchived on the
download device. With the digivu this can be done via the
digipostpro using the digivu conguration menu when the digivu
is inserted (see page 21). With the digifobpro this can be done on
the device itself or by using digiConnect on a PC.
Configuring Your digivu
Configuring Your digivuConfiguring Your digivu
Configuring Your digivu
Page - 21
Conguring your digivu via the digipostpro
To congure a digivu via your digipostpro, the digivu menu
option must be turned on in the conguration menu.
Connect your digivu to the digipostpro ensuring that the
digipostpro is powered. Once any upload has been completed, to
enter the digivu conguration menu, press OK.
Only digivu’s V4 and upwards can be congured via digipostpro.
File System
In this menu, you are given the option to either view all
les on the digivu or delete them.
The Files option navigates you to the list of les on the digivu.
Depending on the usage of the device, the les may be a
combination of VU les and Driver Card les. This list gives you
limited le information; analysis of those les on the digipostpro
is unavailable.
By pressing OK on a specic le, this gives further options to
either delete that individual le or change it’s archive status.
Deleting a le
If delete is selected, the device will ask whether you are
sure. To conrm deletion, highlight the green tick and
press OK. This function should be used with caution.
File Options - Archive status
Selecting the File Options icon will give you the ability
to change the archive status of that individual le. If
that le has already been uploaded to the digipostpro,
this will have been set as archived. Once a le is marked as
‘Archived’ it will not be uploaded again.
To change the archive status, use the left/right buttons before
pressing 

 . A le that has its archive ag changed will be
uploaded the next time the digivu is inserted.