Need help?Do you have a question about the TACKLIFE RES004 and is the answer not in the manual?
General| Type | Reciprocating Saw |
|---|---|
| Power Source | Corded Electric |
| Voltage | 120V |
| Power | 900W |
| Amperage | 7.5 Amps |
| Safety Features | Lock-off switch |
Keep work area clean, avoid explosive atmospheres, and keep children away.
Match plugs, avoid grounded surfaces, don't expose to rain, don't abuse cord, use outdoor extension cords, use RCD.
Stay alert, use PPE, prevent unintentional starting, don't overreach, dress properly, use dust collection.
Use correct tool, don't force, maintain tools, keep cutting tools sharp, use as instructed.
Use correct charger/battery, avoid short circuits, handle battery fluid carefully, avoid heat/fire.
Have tool serviced by qualified personnel using identical replacement parts.
Hold by insulated surfaces, wear dust mask, avoid hidden cables.
Use by supervised children, replace damaged cords, suitable for indoor use only.
Use only specified accessories and compatible equipment to avoid injury risk.
Use 1/2" universal shaft blades, optimized blades available separately.
Connect battery to charger, insert plug, observe LED indicators for charging status.
Allow pack to click into place, press release button to remove.
Press button to check status on display LED, indicating charge level.
Turn chuck, insert blade, release chuck to lock. Ensure teeth point down.
Undo locking lever, move footplate for cutting depth, lock lever.
Use switch to adjust pendular movement for fine cuts or faster work rate.
Press safety lock-out then ON/OFF switch to turn on; release ON/OFF switch to turn off.
Lightly press ON/OFF switch for low speed; increasing pressure increases speed.
Ensure footplate is in contact with workpiece for safe placement and operation.
Check material, ensure ventilation is clear, switch on before moving to material, handle jams, use correct blade/speed, saw at constant speed.
Keep appliance clean, dry, free from oil/grease; clean housing with soft cloth; replace blunt blades.
Have power tool repaired by service centre or qualified electrician using genuine parts.
Dispose of packaging at recycling plant; do not dispose of tools/batteries in domestic waste.
To Next Page
