EasyManua.ls Logo

Taco 0034ePlus

Taco 0034ePlus
16 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
DESCRIPTION:
The 0034ePlus is a high performance, variable speed, high-eciency, wet-rotor
circulator with an ECM, permanent magnet motor and an advanced digital LED
display controller for easy programming and diagnostic feedback. With 5 operating
modes and simple keypad programming, its variable speed performance curves are
equivalent to the Taco 009, 0010, 0011, 0012, 0012 3-Speed, 0013, 0013 3-Speed &
0014. Ideal for large residential and light commercial hydronic heating, chilled water
cooling and domestic hot water systems. The 0034ePlus reduces power consumption
by up to 85% compared to equivalent AC permanent split capacitor circulators.
APPLICATION:
Maximum operating pressure: 150 psi (10.3 bar)
Minimum NPSHR: 18 psi at 203˚F (95˚C)
Maximum uid temperature: 230°F (110˚C)
Minimum uid temperature: 14°F (-10˚C)
Electrical specications:
Voltage: 115/208/230V, 50/60 Hz, single phase
Maximum operating power: 170W
Maximum amp rating: 1.48 (115V) / .70 (230V)
Equipped with a cast iron or stainless steel casing
SS Model suitable for open loop potable water systems
Taco circulator pumps are for indoor use only – employer uniquement a l’interieur
Acceptable for use with water or maximum of 50% water/glycol solution
FEATURES:
Simple keypad programming
Digital LED screen display (Watts, GPM, Head, RPM and diagnostic error codes)
Five operating modes to match any system requirements - activeADAPT,
Constant Pressure, Proportional Pressure, Variable Fixed Speed or 0-10V DC input
Replaces all single speed and 3-speed circulators in its class
ECM performance equivalent to Tacos 009, 0010, 0011, 0012, 0013 & 0014 circulators
Multi-color LED display showing power on, mode setting and error code diagnostics
Use with a Taco ZVC Zone Valve Control or SR Switching Relay for ON/OFF operation
Nut-capture feature on anges for easier t up
Dual electrical knockouts and removable quick-connect terminal strip for easy wiring
Double insulated
Whisper quiet operation
BIO Barrier® protects the pump from system contaminants
SureStart® automatic unblocking and air purging mode
Rotatable control cover to allow any pump body orientation
INSTALLATION:
WARNING: Do not use in swimming pool or spa areas. Pump has not been investigated for these applications.
AVERTISSEMENT : Ne pas utiliser dans une piscine ou un spa. La pompe na pas été étudiée pour ces applications.
CAUTION: The addition of petroleum based uids or certain chemical additives to systems using TACO equipment
voids the warranty. Consult factory for uid compatibility.
ATTENTION : Lajout de liquides à base de pétrole ou de certains additifs chimiques à des systèmes utilisant un
équipement TACO annule la garantie. Consultez le fabricant pour connaître la compatibilité de liquides.
CAUTION: Installations at elevations over 5000 feet must have higher ll pressure of 20 psi minimum to prevent
pump cavitation and ashing. Premature failure may result. Adjust expansion tank pressure to equal ll pressure.
A larger size expansion tank may be required.
ATTENTION : Des installations à des altitudes de plus de 1600 mètres doivent présenter une pression de remplissage
plus élevée de 20 psi
au minimum an d’éviter toute cavitation ou ashing de la pompe. Une défaillance prématurée peut en résulter. Réglez la pression
du réservoir d’expansion de façon qu’elle soit égale à la pression de remplissage. Un réservoir d’expansion d’une taille supérieure
peut être nécessaire.
Instruction Sheet
ECM High-Eciency Circulator with Digital Display Controller
102-544
SUPERSEDES: NEW EFFECTIVE: December 2, 2019
Plant ID No. 001-5021
-1-
Certified to
NSF/ANSI 61 & 372
Figure 1
Cast Iron model: 0034ePlus-F2
Stainless Steel model: 0034ePlus-SF2
Question and Answer IconNeed help?

Do you have a question about the Taco 0034ePlus and is the answer not in the manual?

Taco 0034ePlus Specifications

General IconGeneral
BrandTaco
Model0034ePlus
CategoryController
LanguageEnglish

Summary

Product Overview and Specifications

Description

Overview of the circulator's high-performance, variable speed, ECM motor, and digital LED display controller.

Safety and Cautions

Important warnings regarding pool/spa use, petroleum fluids, and elevation pressure requirements.

Installation and Mounting

Electrical Installation Safety

Precautions for wiring, grounding, and wire suitability.

Electrical Connections and Startup

Advanced Operating Modes (Part 1)

activeADAPT Mode Details

Explanation of the automatic, self-adjusting proportional pressure mode.

Constant Pressure Mode Details

Details on maintaining desired constant pressure curves.

Advanced Operating Modes (Part 2)

Proportional Pressure Mode Details

Explanation of maintaining desired head proportional pressure curves.

Advanced Operating Modes (Part 3)

Fixed Speed Mode Details

Instructions for setting variable fixed speed from 1% to 100%.

External Control Connections

Analog Signal Operation

Troubleshooting and Error Handling

Diagnostic Error Codes and Remedies

List of faults, causes, and remedies for LED error codes.

Circulator Unlocking Procedure

Steps to resolve locked or sticking circulator issues.

Related product manuals