M850-00
T800 Ancillary Equipment
H11
Copyright TEL 31/09/98
Rack Frame PCBs
T800-50-0000
The T800-50-0000 backplane PCB is designed to allow a T800-22-0000 rack frame to be
easily configured as either a base station or repeater. The PCB mounts across the rear
panel of the T800-41-0002 double module rack frame guide, enabling a T800 Series II
receiver and exciter/transmitter to plug directly into the D-range sockets provided on
the inner side of the PCB (both D-range 1 and D-range 2 are provided for). The other
side of the PCB features a programming port, D-range connectors which provide all
module inputs and outputs, and two DIP switches for external channel selection.
Refer to the T800 Ancillary Equipment Service Manual for more information.
T800-50-0001
The T800-50-0001 is similar in function and design to the T800-50-0000, but is designed
to allow connection of TA087 or TA387 channel select panels. It has one 25-way OEM
D-range connector, but will not accept personality PCBs.
T800-52-0000
The T800-52-0000 is similar in function and design to the T800-50-0000, but is designed
for use in Quasi-Sync applications. The PCB has an external reference D-range fitted
and has provision for connecting TA087 or TA387 channel change/speaker panels and a
TA136 alarm panel. The T800-52-0000 will not accept personality PCBs.
T800-60-0000
The T800-60-0000 personality PCB is designed to plug into the two 25-way D-range
sockets on the T800-50-0000 backplane PCB. The T800-60-0000 provides channel selec-
tion for both receiver and exciter/transmitter via a single DIP switch, remote channel
selection and alarm monitoring via Micromatch sockets, and receiver and exciter/trans-
mitter inputs and outputs via a 25-way D-range socket.
To Next Page
Loading...
Need help?
General
