Why does my Tait TB9100 base station make random transmissions?
If the Tait Accessories base station appears to make random transmissions, the CWID feature may be enabled. These transmissions are made according to the configured settings, so no action is required.
What to do if there is no power or LEDs on Tait Accessories control panel?
If there is no power or LEDs on the control panel, it could be due to the system control bus not being connected to the control panel, or bent pins on the 15-pin D-range plug on the subrack. Check the I2C cable connections. Also, replace or repair the D-range plug.
How to fix Tait TB9100 when I can’t send microphone audio?
If you can't send microphone audio, it might be because the correct buttons haven't been pressed on the control panel to select either P25 or Analog mode for the microphone, or if making a P25 call, the feature is not enabled. Ensure the correct mode is selected. Also, check using the CSS that there is a feature license for the P25 common air interface.
Why supplementary services don't work in Tait TB9100?
If supplementary services aren’t working, it could be because the features and permissions have not been enabled correctly. Check the service profiles. The service profile attached to the channel enables supplementary services on the RF receiver. The service profile attached to the calling profile enables supplementary services on the analog line in.
What does 'Mismatch warning on receive' mean on Tait Accessories?
If you are getting a 'Mismatch warning on receive' with your Tait Accessories, it indicates that the base station isn't receiving or the analog gateway isn't passing the signal on to the network. To resolve this, use the CSS to monitor calls and check for any mismatch between the received call and the current calling profile.
Why aren’t supplementary services working on my Tait TB9100 Accessories?
If supplementary services aren't working on your Tait Accessories, it's possible that the features and permissions haven't been enabled correctly. You should check the service profiles. The service profile attached to the channel enables supplementary services on the RF receiver, and the service profile attached to the calling profile enables supplementary services on the analog line in.
What to do if all reciter LEDs are on in Tait Gateway?
If all reciter LEDs are illuminated on your Tait Gateway, it indicates that the digital board is not communicating with the network board. Replace the reciter module and send the faulty module for servicing.
How to fix a red alarm LED that is steady on Tait Gateway?
If the alarm LED on your Tait Gateway is red and steady (not flashing), it means the base station is in Standby mode. Use CSS to put the base station in Run mode.
What does it mean when all reciter LEDs are on in Tait TB9100 Accessories?
When all reciter LEDs are on, it means the digital board is not communicating with the Network board. Replace the reciter module and send the faulty module for servicing.
How to resolve mismatch warning on receive in Tait TB9100 Accessories?
A mismatch warning on receive indicates the base station isn't receiving, or the console gateway isn't passing the signal on to the network. Use the CSS to monitor calls and check that there is no mismatch between the received call and the current calling profile.
Pre-installation checks and site requirements.
Steps for installing and configuring the Customer Service Software.
Initial setup and testing before site installation.
Description of front panel controls and indicators.
Common issues, their causes, and recommended actions.
Procedure for backing up system configuration data.
General| Brand | Tait |
|---|---|
| Model | TB9100 |
| Category | Accessories |
| Language | English |
To Next Page
