What to do if the power LED is on but nothing else works on Tait TB9100?
If the power LED on the control panel is on, but nothing else works, the panel may be disabled. Check that the control panel is enabled on the CSS (Configure > Network Element > Miscellaneous).
Why is Tx stuck on in Tait Accessories?
If Tx is stuck on, the Tx and Rx frequencies are likely the same. Reconfigure Tx and Rx with different frequencies.
What does it mean when all reciter LEDs are on in Tait TB9100 Accessories?
When all reciter LEDs are on, it means the digital board is not communicating with the Network board. Replace the reciter module and send the faulty module for servicing.
What does mismatch warning on transmit mean for Tait TB9100?
A mismatch warning on transmit means the base station isn't transmitting, or the console gateway isn't passing the signal on to the network because the calling profile specifies an encryption key, but that key is not loaded.
How to resolve mismatch warning on receive in Tait TB9100 Accessories?
A mismatch warning on receive indicates the base station isn't receiving, or the console gateway isn't passing the signal on to the network. Use the CSS to monitor calls and check that there is no mismatch between the received call and the current calling profile.
Why is Tait TB9100 channel group interface not working?
The channel group interface may not be working because the base station does not have a voice networking feature license, the multicast address is incorrect or keyed connectors were not used. Obtain the required license and enable the feature. Check that the CSS still connects to the base station, and that the multicast address is correct. If the issue persists, replace module and send faulty module for servicing.
How to fix a steady red alarm LED on Tait TB9100?
If the Alarm LED is red and steady (not flashing), the base station might be in Standby mode. Use the CSS to put the base station in Run mode.
Why does Tait TB9100 PA have low power?
If the PA has low power, the channel might be configured to low power, or the PA may have suffered partial damage. Use the CSS to check the power settings. If the power settings are correct, replace the module and send the faulty module for servicing.
Why is Tait TB9100 control panel behavior random?
If the control panel behavior is random, as if buttons are being pressed, the I2C cable might not be connected to the PMU. Check the I2C cable connection to the PMU - if the I2C cable is not connected to the PMU, the system control bus is not properly terminated and will account for any strange behaviour.
What to do if front panel speaker transmits unintelligible sounds on Tait TB9100?
If the front panel speaker transmits unintelligible sounds, it might be because an encrypted P25 call is being monitored or received. You can turn the speaker off, or take no action, as only other radios with an encryption decoder can decrypt encrypted calls.
General| Brand | Tait |
|---|---|
| Model | TB9100 |
| Category | Accessories |
| Language | English |
Pre-installation checks and site requirements.
Steps for installing and configuring the Customer Service Software.
Initial setup and testing before site installation.
Description of front panel controls and indicators.
Common issues, their causes, and recommended actions.
Procedure for backing up system configuration data.
To Next Page
