Why supplementary services don't work in Tait TB9100?
If supplementary services aren’t working, it could be because the features and permissions have not been enabled correctly. Check the service profiles. The service profile attached to the channel enables supplementary services on the RF receiver. The service profile attached to the calling profile enables supplementary services on the analog line in.
How to fix Tait TB9100 when I can’t send microphone audio?
If you can't send microphone audio, it might be because the correct buttons haven't been pressed on the control panel to select either P25 or Analog mode for the microphone, or if making a P25 call, the feature is not enabled. Ensure the correct mode is selected. Also, check using the CSS that there is a feature license for the P25 common air interface.
What to do if there is no power or LEDs on Tait Accessories control panel?
If there is no power or LEDs on the control panel, it could be due to the system control bus not being connected to the control panel, or bent pins on the 15-pin D-range plug on the subrack. Check the I2C cable connections. Also, replace or repair the D-range plug.
General| Brand | Tait |
|---|---|
| Model | TB9100 |
| Category | Accessories |
| Language | English |
Pre-installation checks and site requirements.
Steps for installing and configuring the Customer Service Software.
Initial setup and testing before site installation.
Description of front panel controls and indicators.
Common issues, their causes, and recommended actions.
Procedure for backing up system configuration data.
To Next Page
