What does 'Mismatch warning on receive' mean on Tait Accessories?
If you are getting a 'Mismatch warning on receive' with your Tait Accessories, it indicates that the base station isn't receiving or the analog gateway isn't passing the signal on to the network. To resolve this, use the CSS to monitor calls and check for any mismatch between the received call and the current calling profile.
What does 'Mismatch warning on transmit' mean on Tait TB9100?
If you are getting a 'Mismatch warning on transmit' with your Tait Accessories, it indicates that the base station isn't transmitting or the analog gateway isn't passing the signal on to the network. This may be because the calling profile specifies an encryption key, but that key is not loaded.
How to fix TX stuck on issue on Tait TB9100 Accessories?
If your Tait Accessories are experiencing TX stuck on, it means that the TX and RX frequencies are the same. To fix this, reconfigure TX and RX with different frequencies.
What does it mean when the alarm LED is red and steady on Tait Accessories?
If the alarm LED on your Tait Accessories is red and steady (not flashing), it means the base station is in standby mode. To resolve this, use CSS to put the base station in Run mode.
Why is there no power or LEDs on my Tait TB9100 control panel?
If there is no power or LEDs on the control panel of your Tait Accessories, it could be due to a couple of reasons. First, check the I2C cable connections, as the system control bus might not be connected to the control panel. Also, inspect the 15-pin D-range plug on the subrack for bent pins, and replace or repair the D-range plug if necessary.
Why are all reciter LEDs on my Tait TB9100 illuminated?
If all reciter LEDs are illuminated on your Tait Accessories, it indicates that the digital board is not communicating with the network board. To resolve this, replace the reciter module and send the faulty module for servicing.
Why aren’t supplementary services working on my Tait TB9100 Accessories?
If supplementary services aren't working on your Tait Accessories, it's possible that the features and permissions haven't been enabled correctly. You should check the service profiles. The service profile attached to the channel enables supplementary services on the RF receiver, and the service profile attached to the calling profile enables supplementary services on the analog line in.
Why is my desired Tait Accessories feature not operating?
A feature might not be working because the feature license is missing or the feature is not enabled. First, check that you have the necessary feature licenses. You can consult the CSS help or User’s Manual. Also, check the system log for messages indicating a missing feature license. If the license is present, use the CSS to enable the feature.
Why base station performs Task Manager actions unexpectedly when going into Run mode in Tait TB9100?
The base station may perform Task Manager actions unexpectedly when going into Run mode because the digital input cable is not attached and the inputs are active low. Check the cable carrying digital inputs. Try to avoid Task Manager tasks that trigger when digital inputs float high.
Why test tones can’t be heard on Tait Accessories?
If test tones can’t be heard, it is because IMBE does not pass on tones higher than 400 HZ. Ensure test tones are less than 400 Hz.
Pre-installation checks and site requirements.
Steps for installing and configuring the Customer Service Software.
Initial setup and testing before site installation.
Description of front panel controls and indicators.
Common issues, their causes, and recommended actions.
Procedure for backing up system configuration data.
General| Brand | Tait |
|---|---|
| Model | TB9100 |
| Category | Accessories |
| Language | English |
To Next Page
