48 Installation TB9100/P25 CG/P25 TAG Installation and Operation Manual
© Tait Limited March 2014
Making Test
Transmissions
You can verify that the base station is operating correctly by making some
test transmissions. (If testing a console gateway, audio quality can be tested
through the CTU.)
1. Ensure that the base station is correctly connected to an appropriate
load and that all RF connectors are secure.
2. Plug the Tait TMAA02-01 microphone supplied with the base
station into the RJ-45 socket on the control panel (for a list of the
microphone pin allocations refer to “Microphone Connection” on
page 140).
3. Use the microphone button to select the speech mode for the
transmission. Check that the microphone LED behaves correctly.
Refer to “Microphone Operation” on page 82.
4. Turn on the speaker audio by pressing the speaker button.
5. Press the PTT switch on the microphone and make your
transmission. Check that:
■ the red transmit LED turns on
■ there are no alarms generated
■ the audio quality on the receiving SU (if testing a base station), or
CTU (if testing a console gateway) is good
6. When the receiving SU answers your transmission, check that:
■ the green receive LED turns on
■ the audio quality from the speaker in the control panel is good
(adjust the speaker volume as required)
Connecting the CSS for the First Time and Setting the IP Address
Before the base station is installed on site, you need to provide it with a name
and its proper IP address. Make sure that you do not lose this address. You
must also add the same name and IP address to the CSS connections list, so
that you can select the base station when you want to re-connect to it.
1. Run the CSS.
2. Configure the CSS PC so that it has an IP address and subnet mask
that is compatible with the base station, For example: IP address =
192.168.1.1, subnet mask = 255.255.255.0. For more information,
see the Basic Tasks section of the CSS Help or manual.
3. Connect to the base station by selecting from the connection list the
default entry with the IP address 192.168.1.2. If you have trouble
connecting, see the CSS Help or manual for more information and
for troubleshooting assistance.
4. You are asked to enter the base station password. Don’t enter
anything; just click OK. (New base stations have a null password.)
To Next Page
Loading...
Need help?
General
