Need help?Do you have a question about the Tait T800 SL2 25W and is the answer not in the manual?
General| Brand | Tait |
|---|---|
| Model | T800 SL2 25W |
| Category | Accessories |
| Language | English |
Indicates that this document is a service manual for the T800 SL2 Base Station equipment.
Details methods for replacing leaded components, surface mount devices, and cased mica capacitors.
Warns about the susceptibility of CMOS devices to static discharge and recommends antistatic precautions.
Describes two methods for removing leaded components from plated-through hole PCBs.
Describes the circuit operation of the T855 receiver, covering various sections and block diagrams.
Details tuning and adjustment procedures, including channel programming and synthesiser alignment.
Provides test procedures and flow charts to help locate hardware problems in the T855 receiver.
Describes the receiver front end, including filters, amplifiers, and mixer stages.
Explains how the noise mute operates on detected noise outside the audio bandwidth.
Details the audio processor's function, including recovered audio processing and output paths.
Explains the power supply design, operation voltage, and the function of various regulators.
Describes the overall system control using the 80C51 microcontroller and its main tasks.
Outlines the short tuning procedure for reprogramming the receiver to a frequency outside its switching range.
Details steps for synthesiser alignment, including connecting voltmeter and tuning VCO trimmer.
Describes the procedure for aligning the PA output power, including connecting a power meter.
Describes the circuit and operation of the T803 Tone Remote, including block diagrams.
Details how to install, configure, and test the T803 Tone Remote in a T800 SL2 sub-rack.
Lists detailed specifications for the T803 Tone Remote, including line levels and tone parameters.
Explains how the T803 detects guard tones, function tones, and keys the transmitter.
Details the T803's monitoring of eight alarm sources and how alarms are latched and actioned.
Provides steps for troubleshooting common issues with the T803.
Provides a brief description of the T800-23-0011 Switch Mode Power Supply and its specifications.
Describes the components of the T800-23-0011 power supply, including PSU module and loom.
Outlines test procedures to confirm the T800-23-0011 is set up correctly and operational.
Lists possible power supply fault symptoms, causes, and solutions.
Provides specific information on servicing procedures for the T800-23-0011.
Describes the configuration for a talk-through repeater where receiver keys transmitter.
To Next Page
