M8SL2-00-002-812 Mechanical A2.3
© Copyright Tait Electronics Limited August 2004. All rights reserved.
2.3 Disassembly/Reassembly
2.3.1 Receivers/Transmitters
To carry out alignment or change option links, you need to remove only the top cover,
i.e. the one on the opposite side to the main D-range connector (D-range 1/PL100).
You need to remove the bottom cover to:
• access transmitter RF power transistors and many SMD components
• change solder blob links
• fit test leads to circuit block access points.
2.4 Cover Screw Torques
Receivers/Transmitters … 1.36Nm/12in.lbf.
To Next Page
Loading...
