M8SL2-00-002-812 G1.1
© Copyright Tait Electronics Limited August 2004. All rights reserved.
1 T800 SL2 Installation
1.1 Specifications
Overall Dimensions:
Height … 132mm
Width … 480mm
Depth … 335mm
Weight with Tone Remote … 16kg
Weight without Tone Remote … 13kg
1.2 Mounting
The T800SL2 unit is shipped ready assembled for fitting into racks. All that is required is
for the connection of suitable cables.
1.3 Power Supply
The power rating information for the T800SL2 with the Tait supplied power supply
module (T800-23-0011), is provided on the label located on the top cover as visible in
Figures 1.6.
The power rating information for the T800SL2 for use with a customer supplied DC
power source, is provided on the label located on the top rear of the Transmitter mod-
ule.
In order to comply with the safety requirements of EN60950, the power supply module
used with the T800SL2 must be provided with an easily accessible mains disconnect
device compliant with IEC61058, such as a switch or circuit breaker. This provides the
means to rapidly disconnect the mains power in an emergency.
All Tait supplied racks incorporate a power distribution board with a circuit breaker
easily accessible in the back of the rack, on the lower right hand side (viewed from the
rear). The circuit breaker will disconnect the mains to the entire rack. If only one channel
needs to be mains-isolated and the Tait power supply module is T800-23-0011, then it is
acceptable practice to pull the IEC connector directly out of the power supply module.
If a customer supplied power source is used, it must have the following features:
• An easily accessible and safety compliant mains disconnect device.
• The capability to provide enough current to drive the T800 system.
• Free from excessive ripple or noise.
• Meets all EMC and safety regulations for the intended market.
To Next Page
Loading...
Need help?
General
