EasyManua.ls Logo

Tait T800 SL2 25W - EMC Conformity

Tait T800 SL2 25W
383 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
F1.4 General Information M8SL2-00-002-812
© Copyright Tait Electronics Limited August 2004. All rights reserved.
1.3 Regulatory Information
1.3.1 EMC Conformity
This equipment complies with:
ETSI EN301 349-1 V1.3.1 (2001-09) Electromagnetic Compatibility and Radio Spec-
trum Matters (ERM); Electromagnetic Compatibility (EMC) standard for radio equip-
ment and services; Part1: Common technical requirements.
Tested in accordance to:
BS EN55022: 1998
BS EN61000-3-2: 2001
BS EN61000-3-3: 1995
IEC 61000-4-2: 1995
IEC 61000-4-3: 2002
IEC 61000-4-4: 1995
IEC 61000-4-5: 1995
IEC 61000-4-6: 1996
IEC 61000-4-11: 1994
BS EN55022: 1998 for class B Radiated and conducted emissions, and electromagnetic
susceptibility specifications.
AS/NZS CISPR22: 2002 for class B Radiated and conducted emissions, and electromag-
netic susceptibility specifications.
FCC 47 Part 15: 2001 for class B (Radiated and conducted emissions, and electromag-
netic susceptibility specifications) of the FCC rules for the United States. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must not accept any interference received, including interference that
may cause undesired operation.
Warning: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particu-
lar installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:

Table of Contents

Related product manuals