Tait T800 SL2 25W User Manual

M8SL2-00-002-812 Installation and Configuration D3.1
© Copyright Tait Electronics Limited August 2004. All rights reserved.
3 Installation and Configuration
Caution: This equipment contains CMOS devices which are susceptible to dam-
age from static charges. Refer to Section 1.2 in Part A for anti-static pro-
cedures for handling these devices.
This section of the manual describes how to install and configure the T803 in a T800 SL2
sub-rack and test that it is functioning correctly. It also provides a brief fault finding pro-
cedure.
Note: Unless otherwise specified, the term “PGM800Win” used in this and follow-
ing sections refers to version 4.02 or later of the programming software.
Refer to Section 4 where the parts lists, grid reference index and diagrams will provide
detailed information on identifying and locating components and test points on the
main PCB.
The following topics are covered in this section.
Section Title Page
3.1
3.1.1
3.1.2
3.1.2.1
3.1.2.2
3.1.3
Installation
Backplane Configuration
Auxiliary Inputs/Outputs
Auxiliary Alarms Inputs
Auxiliary Control Outputs
Line Interface
3.3
3.3
3.5
3.6
3.6
3.6
3.2
3.2.1
3.2.2
3.2.3
3.2.4
3.2.4.1
3.2.4.2
3.2.4.3
3.2.4.4
T803 Configuration
Equipment Setup for Level Configuration.
Use of Test Microphone
Test Modes
Level Configuration
Tx Audio – Audio Level from T803 to Transmitter
Line-In Level
Rx Audio – Audio Level from Receiver to T803
Line-Out Level
3.7
3.8
3.8
3.9
3.10
3.11
3.11
3.12
3.15
3.3
3.3.1
Fault Finding
Troubleshooting
3.15
3.16

Tait T800 SL2 25W Specifications

General

Brand	Tait
Model	T800 SL2 25W
Category	Accessories
Language	English