14 Installation TB8100 Installation Guide
© Tait Electronics Limited February 2007
2. Rotate the carton carefully onto its side c and then onto its top d,
ensuring that none of the flaps is trapped underneath.
3. Slide the carton upwards over the foam cushions and lift it away
e.
Remove the cushion from the bottom of the base station
f.
4. Rotate the base station and cushion carefully over the rear of the base
station
g so that the base station is the right way up with the cushion
on top
h. Remove the cushion from the top of the base station i.
Moving the Base
Station
The TBAA03-16 carrying handles can be used to move the base station
once it has been unpacked. The handles fit into the holes in the sides of the
subrack, as shown below.
Disposal of
Packaging
If you do not need to keep the packaging, we recommend that you recycle
it according to your local recycling methods. The foam cushions are CFC-
and HCFC-free and may be burnt in a suitable waste-to-energy combustion
facility, or compacted in landfill.
Figure 1.4 Base station carrying handles
To Next Page
Loading...
Need help?
General
