TBA0STU/TBA0STP CTU Operation Manual Appendix A - CTU Accessories 35
© Tait Electronics Limited September 2005
Appendix A - CTU Accessories
The TBA0STU base station CTU is supplied with the following accessories:
■ a selection of cables which allow the CTU to be connected to a TB7100,
TB8100, or TB9100 base station
■ an adaptor board for connecting the CTU to a TB7100 base station
■ DC power cables
■ a DC power connector for use with the PMU auxiliary DC output (refer
to “Using a PMU to Power the CTU” on page 37)
■ tuning tools.
These accessories are described and identified in Figure A.1 on page 36.
To Next Page
Loading...
