152 Disassembly and Reassembly TM8100/TM8200 Service Manual
© Tait Electronics Limited November 2007
8. Remove the elastomeric strips F, speaker clamp h
1
, speaker I, LCD
1@, keypad 1!, lightpipes j and 1), and, if fitted, the concealed
microphone
1#.
Important When replacing the LCD, carefully remove the protective
plastic film from the LCD. Take care not to scratch the soft
polarizer material on the top side of the LCD.
Important When fitting the speaker and the speaker clamp, observe the
orientation of the speaker terminals. Make sure that the legs
of the speaker clamp are positioned under the space frame
as shown in Figure 5.10 on page 150.
1. The speaker clamp h and a new space frame g were introduced in
April 2007.
To Next Page
Loading...
