Charging the battery
1 Desktop charger—ensure that the
charger is connected to the correct Tait
power adaptor.
Multi-charger—ensure the charger is
powered on.
2 Put the battery in the charger.
Note: For optimal results, the radio
should be turned off while in the charger.
The red ‘Charging’ LED glows to indicate
that the battery is charging.
Note:
If the amber ‘Fault’ LED lights up,
refer to
“Troubleshooting your charger”
on the next page.
3 The green ‘Ready’ LED on the charger
glows when the battery is fully charged,.
Remove it when you are ready—the
charger will not overcharge the battery.
Note: If the radio was turned on while being
charged, the battery indicator may not be
accurate when the radio is initially removed
from the charger. After a few seconds, the
battery indicator is updated to display the
amount of charge available in the battery.
Turn your radio off
while charging, for
best results.
To Next Page
Loading...
