TAJIMA TMBR-SC - Page 109

To stop the machine
93
Chapter 5
1
2
3
4
5
6
7
8
9
10
11
XL03
4. To stop the machine
4-1. To stop the machine automatically when reaching the set value (Preset Halt)
4-1-1. Explanation on the screen
[a] The machine will stop when counting reaches the number of the set stitches. (Display of 1D2)
[b] The machine will stop when embroidery stitch length reaches the set length (display of 1D2).
[c] The machine will stop when the number of designs reaches the set numbers. (Display of 1D2).
[d] The machine will stop when counting reaches the number of set stitches. (Display of OIL)
When automatic lubrication system is set to "YES", it will not be displayed.
[e] The machine will stop short of the end code by one stitch (display of 1D2).
YES: To stop
Since embroidery is not finished, it is possible to perform frame back.
NO: Not to stop
[f] The machine will stop when the number of ATH movement reaches the set numbers. (Display of
1D8).
6 Preset Halt
C
Stitch
0
0
0
10
NO
0-999999[st]
Data 0-99999[cm]
Design 0-999[Designs]
Lubrication 0-99*10000[st]
Just before End Code YES/NO
[a]
[b]
[c]
[d]
[e]
1000
ATH cleaning 500~2000
[f]