To increase embroidering efficiency
122
Chapter 5
UO04
8. To increase embroidering efficiency
8-1. To change number of lowering needle bar at slow operation (Main Shaft Inching)
This function targets slow operation when the machine stops in the middle of embroidery and then the
machine restarts. Regarding the number of lowering the needle bar by slow operation at start after thread
trimming or after data set, refer to the detail page. (p.79)
8-1-1. Explanation on the screen
8-1-2. How to operate
The following is the example of setting the number of Start Inching to "3".
(1) To open screen
(2) To select number of lowering needle bar at slow operation
Number of lowering needle bar at slow
operation
To Next Page
Loading...
