To return the frame to the original position
165
Chapter 6
1
2
3
4
5
6
7
8
9
10
11
UO04
3. To return the frame to the original position
3-1. To return the moved frame to the previous position (Manual Offset)
This function is effective only when the frame is moved manually after stopping the machine in the middle of
embroidery.
3-1-1. Explanation on the screen
3-1-2. How to operate
The following is an example of executing manual offset.
(1) To open screen
(2) To perform manual offset
To return the frame to the original position
: To execute
When performing this operation, do not put your hands, etc. on the table. Moving the
frame could injure you.
Pressing SET key will move the frame.
To Next Page
Loading...
