To make optional device available for use
206
Chapter 8
UO04
1-4. Lochrose embroidery device
This setting makes Lochrose embroidery device available for use. For details of the device, refer to the
separate manual "Lochrose embroidery device".
1-4-1. Explanation on the screen
[a] Type of device
L: Equipped to left side
NO: Not to equip
[b] Insert jump before feeding material
Setting whether or not to insert a non-data jump code automatically before feeding out beads
YES: To insert
When beads can not be sewn effectually, select "YES". However, productivity will be
decreased.
NO: Not to insert
[c] Insert jump after feeding material
Setting whether or not to insert a non-data jump code automatically after feeding out beads
YES: To insert
When you desire to tighten stitching tension of beads, select "YES". However, productivity
will be decreased.
NO: Not to insert
[d] Moving up of device at frame stepping
YES: To perform
NO: Not to perform
Selecting "NO" will increase manufacturing efficiency. However, the device could interfere
with the frame resulting in its breakage depending on design or frame type to use.
YES/NO
F3
10 Lochrose embroidery device
NO
YES/NO
YES
Device Up at
YES/NO
L
YES
NO/L/R/L+R
Jump Insertion
Before feed
Jump Insertion
After feed
[a]
[b]
[c]
[d]
frame stepping
To Next Page
Loading...
