TAJIMA TMBR-SC - Page 232

To set details of optional device
216
Chapter 8
2-2. Auto Clamp Frame
After finishing of the embroidery, move the frame to the position where the frame does not interfere with the
needle bar case.
This function can be used only when "C-7: Frame type Auto Clamp Frame T" is set.
2-2-1. Explanation on the screen
2-2-2. How to operate
The following is an example of moving the frame after finishing of the embroidery.
(1) To open screen
(2) To move the frame after finishing of the embroidery
F3
YES/NO
NO
8 Auto Clamp Frame
Frame retraction
Move the frame after finishing of the
embroidery.
YES: To move
NO: Not to move
8 Auto Clamp Frame
YES
TP09