TAJIMA TMBR-SC - Page 40

Screen display
24
Chapter 3
SQ06
1-2. List screen
1-3. Setting screen
1-4. Character/numeric value input screen
The screen shown left will be displayed if B key is
pressed.
Selected item (cursor) will be displayed in yellow.
To lower the cursor, press B key or
Pressing the Set key will switch to "Setting screen".
B
YES
1 Auto Color Change (AC) / Auto Start (AS)
2 Needle Bar Selection
3 Data Conversion
4 Repeat
5 Automatic offset
6 A.S. after Auto Data Set
10 Needle Bar Color
Cursor
Select YES/NO by using the jog dial and press SET
key.
To lower the cursor, press SET key or
To return the screen, press E key.
YES
B
AC YES/NO
AS YES/NO
YES/NO
Auto start at same color
NO
NO
NO
1 Auto Color Change (AC) / Auto Start (AS)
1. File name (up to 8 characters)
2. To return the cursor or delete the character.
3. To determine the input character and numeric
value.
4. Switching of large letter/small letter
[How to input]
After finishing input, press Enter and SET key.
T
6 Changing design name
G0012
1
2 3
4