TAJIMA TMBR-SC - Page 39

Screen display
23
Chapter 3
1
2
3
4
5
6
7
8
9
10
11
XL08
1/1
26
1:23:45
19. Current set frame
20. Software Frame Limit
21. Current number of stitches
22. Total stitch number of design
23. Number of times of embroidering this design
24. Current frame position (mm)
A distance from the absolute origin.
25. Start point of design
Tubular goods frame
Cap frame
Border frame
Tubular goods auto clamp frame
X-extension unit
X-EXT
With setting
26. Without repeat setting
The display shown below will appear if
Automatic Start after Automatic Data Set is set
to YES.
27. Time left until the completion of embroidery
(hours, minutes, and seconds)
28. Completed ratio of embroidery
29. With repeat setting
Repeat count up to the present/Total repeat
count
30. Time left until the compeltion of the current
embroidery design (hours, minutes, and
seconds)
31. Time left until the completion of repeat
embroidery (hours, minutes, and seconds)
32. Ratio of finishing until the completion of repeat
embroidery
TAJIMA_W
0
1000
5
21
23
2425
14117
22
1/1 1:23:45
27
Without repeat setting
28
3/50
29
11:32 / 4:32:50
30 31
With repeat setting
32
19
20
Displayed only in the case of TMBR-SC.