TAJIMA TMBR-SC - Page 68

Decision of an embroidery design and the color change sequence
52
Chapter 4
VN03
4-2-3. How to operate (to insert offset mark)
The following is an example of inserting the offset mark between step 2 and step 3.
(1) To select step to insert offset mark
(2) To insert offset mark
To delete offset mark
4-2-4. How to operate (TMBR-SC only)
The following is an example of setting the presser foot FB lower dead point to "+15 mm" in step 2.
(1) To select Step 2
(2) To move the cursor to the presser foot setting column
2
9
3
1
2
9
3
1
Blinking
2
9
3
1
Blinking
2
9
0.8 mm