TANDBERG TCD 310 - Replacing the Drive Belt

3.3. REPLACING THE DRIVE BELT
Before starting this operation remove the top plate
and the cassette compartment lid.
1. Wind a piece of sellotape a few times around
each capstan (see fig.). This is done to ensure
that the capstans and flywheels will stay in
place during the dismantling.
2. Unhook the connecting spring from the
mounting plate. Be sure to note which notch
the spring is fastened to, so that you will be
able to replace it correctly.
3. | Unhook the drive belt from the pulley.
4. Remove the circlip on the front side of the
cassette compartment (see fig.).
5. Unhook the locking lever from the cassette
compartment. The cassette compartment can
now swing upwards.
6. Unscrew the two screws (B) holding the guide
brackets for the mounting plate.
7. Unhook the two guide brackets and pull them
out through the holes (C).