Need help?Do you have a question about the TANDBERG TR-200 and is the answer not in the manual?
General| Frequency response | 20Hz to 20kHz |
|---|---|
| Speaker load impedance | 4Ω to 16Ω |
| Weight | 7.5kg |
| Inputs | phono, aux, tape |
| Tuning range | FM: 87.5-108 MHz, MW: 530-1600 kHz |
| Input sensitivity | 2.5mV (MM), 150mV (line) |
| Outputs | tape |
Procedure for removing the unit's side and top panels.
Steps to remove the front panel and its components.
Instructions for removing the dial cover glass.
Detailed steps for removing switch plungers and housing.
Guidance for reassembling slide switches.
Adjusting the FM oscillator and aerial circuit.
Aligning FM intermediate frequency stages and the discriminator.
Adjusting AFC, muting, and crosstalk levels.
Lists of transistors and diodes used in the device.
Lists of potentiometers and integrated circuits.
Technical specifications for the FM receiver section.
Technical specifications for the audio amplifier section.
Performance data for the stereo decoder.
Steps to remove the unit's cabinet and dummy decoder board.
Installing the decoder board, bracket, and stereo indicator lamp.
Required test equipment and basic alignment steps.
Comprehensive guide for aligning decoder circuits and levels.
To Next Page
