Tangent Dab2go+ User Manual

• During standby mode, press the STANDBY button to turn the device to operation mode.
• If it is the first time to enter DAB mode, the device will automatically scan the DAB/DAB+
stations.
Operations
Main Menu
Press MODE button to go to the main menu, you can rotate the < TUNING /SELECT> control to
select different operation mode (DAB, FM, AUX IN or Bluetooth) and then press the < TUNING
/SELECT> control to confirm.
Rotate the –VOLUME+ control to increase or decrease the volume during playing.
At any operation mode, press BACK button to go to the previous screen until back to its playing
mode.
Built in Rechargeable Battery
The LED near the ON/OFF switch is to indicate the charging status of the built in battery. When
the device is ON or the battery is fully charged, the LED lights green. If battery is under
charging, the LED lights red.
The icon on the top right corner of the display shows the level of the battery power.
The icon is shown when the battery power is low.
Antenna
The F-connector antenna has already been installed on the device. To get good
reception for DAB/FM broadcasting, always extend the antenna with its full length.
System Menu and Settings
At any operation mode, press and hold MENU button to enter system menu in order to change
device configurations. Rotate the < TUNING /SELECT> control to select the submenu and then
press the < TUNING /SELECT> control to confirm.

Tangent Dab2go+ Specifications

General

Brand	Tangent
Model	Dab2go+
Category	Radio
Language	English