This device is intended only for OEM integrators under the following conditions：
The module can be used to installation in other host.
the transmitter module may not be colocated with any other transmit or antenna. The module shall
be only used with the integral antenna(s) that has been originally tested and certified with this module.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirement
with this module installed (for example, digital device emission, PC peripheral requirements, etc.)
The final end product must be labeled in a visible area with the following: ”Contains FCC ID:
II78265NG”.The equipment complies with FCC RF exposure limits set forth for an uncontrolled
environment. The equipment must not be co-located or operating in conjunction with any other antenna
or transmitter.
To Next Page
Loading...
Need help?
General
